Skip to content

Furnace Repair in Los Altos Hills, CA

Serving Los Altos Hills and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (669) 274-2169

The short answer

ArcticFlow AC Repair repairs gas furnaces in Los Altos Hills (ZIP 94022), finding the real cause of no-heat, short-cycling, and noise problems before recommending a fix. Bay Area Air District rules do not require you to replace a working furnace, so repairing the one you have is often a reasonable choice.

When a furnace quits on a cold, damp night in Los Altos Hills, you want a clear answer about what went wrong and what it will take to fix it. ArcticFlow AC Repair drives out from our base in Santa Clara to repair gas furnaces and the controls, igniters, blowers, and venting that keep them running. Our technicians find the actual fault, explain your options in plain terms, and let you decide whether a repair makes sense for your home. Winters here are mild, so many furnaces sit idle for months and then get asked to run hard on the first chilly mornings. That on-and-off pattern is when weak parts tend to show up.

Common Furnace Problems We Fix in Los Altos Hills Homes

Most furnace calls come down to a handful of causes. Some are quick fixes. Others point to a part near the end of its life. We test before we replace anything, so you aren't paying for parts you didn't need.

A furnace that sat unused through a long, dry summer can collect dust on the flame sensor and burners, and a clogged filter can make it overheat and shut itself off. These problems are common in the Santa Clara Valley because the heating season starts and stops so gradually.

  • Furnace runs but blows cold or lukewarm air
  • Igniter or flame sensor failure that keeps burners from lighting or staying lit
  • Short-cycling, where the furnace turns on and off every few minutes
  • Blower motor or capacitor problems that cause weak airflow or humming
  • Thermostat wiring or control board faults
  • Limit switch trips caused by restricted airflow or dirty filters
  • Unusual smells, rattles, or squealing when the system starts

What a Furnace Repair Visit Looks Like

We start by asking what you've noticed: when the problem began, whether it happens every cycle, and what the thermostat shows. Then we check the system in order, from thermostat and power to ignition, gas supply, burners, heat exchanger condition, airflow, and venting.

Once we know the cause, we explain it and give you the repair options before we do the work. If a part has to be ordered, we tell you so and make the system as safe as possible in the meantime. Before we leave, we run the furnace through full cycles to confirm it lights, heats, and shuts off the way it should.

Some homes in town have equipment in attics, crawlspaces, or garages that are tight to reach. Let us know where your furnace is when you call, and our technician will arrive ready for the space.

Repair or Replace? What the Air District Rules Mean for You

Many Los Altos Hills homeowners have heard about new Bay Area Air District rules for gas appliances and wonder if they have to get rid of their furnace. They don't. The rules do not require anyone to replace working equipment. They apply only when an existing furnace fails or is replaced.

Looking ahead, gas furnaces manufactured from 2029 on must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when they replace a furnace after that date. If your furnace is in good shape, repairing it now is a sensible choice. If it's older and needing repairs more often, a repair can buy you time to plan a switch to a heat pump on your own schedule instead of during a breakdown.

On incentives: the federal 25C tax credit for heat pumps covered systems placed in service before December 31, 2025, and it is not available for new installations. BayREN and your local clean energy provider may offer heat pump and electrification incentives, but amounts change with each funding cycle. We check the current offer before we bring it up in a quote.

Signs You Should Call Before It Gets Worse

Small furnace problems usually give warning signs. Catching them early can keep a minor repair from turning into a no-heat call on a cold night.

  • Heating bills climbing without a change in how you use the system
  • Some rooms much colder than others
  • A yellow or flickering burner flame instead of a steady blue one
  • The furnace starting several times before it stays on
  • Soot, scorch marks, or a burning smell near the unit

Serving Los Altos Hills and Nearby Communities

We work throughout Los Altos Hills in ZIP code 94022, and in nearby Palo Alto, Los Altos, Mountain View, Cupertino, and Sunnyvale. Our home base is in Santa Clara, so we're a short drive away when your heat stops working. When you contact us, tell us the symptoms you're seeing and we'll set up a time to diagnose the problem.

More services in Los Altos Hills

Related

What to expect

How a visit goes

  1. We find the cause first

    Before we replace a part or suggest new equipment, we test the system and pin down what's actually wrong. You get an explanation of the problem, not just a fix.

  2. We lay out your options

    When there's more than one reasonable path, such as repairing an older furnace versus moving to a heat pump, we explain the trade-offs so you can decide what fits your home and plans.

  3. We check incentives before quoting them

    Heat pump and electrification incentives through BayREN and local clean energy providers change from one funding cycle to the next. We confirm what's currently offered before we mention it in a quote.

FAQ

Common questions

Don’t see your question? Call (669) 274-2169 and we’ll talk it through.

Do I have to replace my gas furnace because of the new Air District rules?

No. The Bay Area Air District rules do not require you to replace working equipment. They apply only when an existing furnace fails or is replaced, so you can keep repairing a furnace that is still sound.

What happens with furnace replacements after 2029?

Gas furnaces manufactured from 2029 on must meet a zero-NOx emission standard. In practice, that steers homeowners toward heat pumps when they replace a furnace after that date.

Why does my furnace act up on the first cold days of the season?

In the Santa Clara Valley's mild climate, furnaces often sit unused for months. Dust on the flame sensor or burners, a clogged filter, or a weak igniter tends to show up when the system first starts running regularly.

Can I still get the federal tax credit for a heat pump?

No. The federal 25C credit covered qualifying heat pumps placed in service before December 31, 2025. It is not available for new installations after that date.

Are there local incentives for switching to a heat pump?

Possibly. Check BayREN and your local clean energy provider. Amounts and availability change with each funding cycle, so we confirm the current offer before including it in a quote.

Is a burning smell from my furnace normal?

A faint dusty smell the first time the furnace runs each season is common. A strong or lasting burning smell, or any smell of gas, is not. Turn the system off and call for service, and contact your gas utility right away if you smell gas.

Tell us what your system is doing

Describe the problem, whether it's warm air from the vents, a furnace that won't start or a strange noise, and we'll schedule a technician to diagnose it and explain your options.

Call (669) 274-2169 Request Service