Skip to content

Heating Repair in Mountain View, CA

Serving Mountain View and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (669) 274-2169

The short answer

ArcticFlow AC Repair fixes gas furnaces, heat pumps and thermostats in Mountain View homes across 94040, 94041 and 94043. We find the actual cause, explain your options before starting, and tell you plainly whether a repair makes sense or replacement is worth considering.

In Mountain View, heating problems tend to show up on the first cold, damp morning of the season, after a furnace or heat pump has sat mostly idle since spring. ArcticFlow AC Repair sends technicians from our Santa Clara base, about 6 miles southeast, to homes in the 94040, 94041 and 94043 ZIP codes. We diagnose and repair gas furnaces, heat pumps, thermostats and the ductwork that connects them. Before any work starts, we explain what we found and what the repair involves, so you can decide with the full picture.

Why Mountain View Heating Systems Act Up

The Santa Clara Valley has dry summers and mild, damp winters. That means most Mountain View heating systems run in short bursts for a few months and then sit for most of the year. Long idle stretches cause their own problems. Dust settles on burners and flame sensors. Igniters that were already weak fail on the first few starts. Filters that were fine in spring get clogged with summer dust and cut airflow just when the system needs it.

Heat pumps work differently. On cool, damp nights they may go into defrost mode, and a failing sensor or control board can trap them in that cycle or make them blow cool air. Many homeowners think this is normal. Often it isn't, and a quick diagnosis can show whether something is actually wrong.

Heating Problems We Repair

We work on the gas furnaces and heat pumps found in most Mountain View houses, townhomes and condos, along with the parts that control them. Common calls include:

  • Furnace that won't light, lights and shuts off, or cycles on and off too often
  • Dirty or failed flame sensors, hot surface igniters and pilot assemblies
  • Blower motors and capacitors that hum, squeal or don't start
  • Pressure switch, inducer motor and limit switch faults
  • Heat pumps blowing cool air, stuck in defrost, or icing up
  • Thermostats that don't call for heat or lose their settings
  • Uneven heat between rooms caused by leaky or disconnected ducts
  • Burning, musty or electrical smells when the heat first comes on

What to Expect on a Repair Visit

Our technician starts by asking what you've noticed: sounds, smells, error codes, or rooms that stay cold. Then we test the system under real operating conditions instead of guessing from symptoms. On a furnace, that includes checking ignition, flame, airflow, venting and safety controls. On a heat pump, we check refrigerant-side performance, defrost operation and the backup heat.

Before we start any work, we explain what failed, why it failed and what fixing it involves. If something we see points to a safety concern, such as a venting problem or a damaged heat exchanger, we'll show you and walk you through your options. We don't push a replacement when a repair will do the job.

Repair or Replace? How the Air District Rules Fit In

Bay Area Air District rules don't require you to replace a furnace or water heater that still works. They apply only when existing equipment fails or gets replaced. Under Rule 9-4, natural gas furnaces manufactured from 2029 on must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when they replace a furnace after that date. If your furnace is older and needs a large repair, it's worth considering that when you weigh your choices.

For water heaters, Rule 9-6 set the small-unit zero-NOx date for 2027, and the Air District Board was considering amendments in November 2026 that could delay it. Check the current rule before you plan a water heater replacement. The federal 25C tax credit for heat pumps applied only to systems placed in service before December 31, 2025, so it's not available for new installations. You can still check BayREN and your local clean energy provider for current heat pump incentives. We confirm the current offer before we quote it.

Serving Mountain View and Nearby Cities

Along with Mountain View, our technicians handle heating repair in Los Altos, Sunnyvale, Palo Alto, Los Altos Hills and Cupertino. All of them are a short drive from our Santa Clara base, which makes it easier to get to you when the heat goes out on a cold night.

More services in Mountain View

Related

What to expect

How a visit goes

  1. We find the cause first

    Before we replace a part or suggest new equipment, we test the system and pin down what's actually wrong. You get an explanation of the problem, not just a fix.

  2. We lay out your options

    When there's more than one reasonable path, such as repairing an older furnace versus moving to a heat pump, we explain the trade-offs so you can decide what fits your home and plans.

  3. We check incentives before quoting them

    Heat pump and electrification incentives through BayREN and local clean energy providers change from one funding cycle to the next. We confirm what's currently offered before we mention it in a quote.

FAQ

Common questions

Don’t see your question? Call (669) 274-2169 and we’ll talk it through.

Why does my furnace start and then shut off after a few seconds?

The most common cause is a dirty flame sensor that can't confirm the burner lit. Other causes include a weak igniter, a venting problem or a pressure switch fault. We test each one so we fix the actual cause.

Is it normal for my heat pump to blow cool air in winter?

Brief cool air during a defrost cycle is normal. If it keeps happening, or the system never seems to warm the house, there may be a problem with a sensor, the defrost control, refrigerant or the backup heat.

Do I have to replace my gas furnace because of the Air District rules?

No. The rules don't require replacing working equipment. They apply only when a furnace fails or is replaced, and the zero-NOx standard covers furnaces manufactured from 2029 on.

Can I still get the federal tax credit for a heat pump?

No. The 25C credit covered qualifying heat pumps placed in service before December 31, 2025. You can check BayREN and your local clean energy provider for current incentives.

Which parts of Mountain View do you serve?

We serve homes throughout ZIP codes 94040, 94041 and 94043, plus nearby Los Altos, Sunnyvale, Palo Alto, Los Altos Hills and Cupertino.

What should I check before calling for heating repair?

Make sure the thermostat is set to heat and has power, check that the furnace switch is on, and replace a dirty filter. If the heat still doesn't work, or you smell gas or burning, turn the system off and call for service.

Tell us what your system is doing

Describe the problem, whether it's warm air from the vents, a furnace that won't start or a strange noise, and we'll schedule a technician to diagnose it and explain your options.

Call (669) 274-2169 Request Service